PA66|杜邦美國|101L本色顆粒

PA66|杜邦美國|101L本色顆粒

基本信息品牌：

美國杜邦牌號：101L NC010

品名：PA66型號：101L NC010

產品用途：塑膠制品廠

外形尺寸：25KG

生產企業：美國杜邦

貨號：101L NC010

是否進口：是

PA66 美國杜邦 101L NC010

PA66塑料

PA66又稱尼龍66，俗稱尼龍雙6 英文名：Polyamide 66，縮寫nylon 66。

別名

尼龍-66；尼龍66樹脂；聚酰胺-66；聚己二酰己二胺；Polyamide  66

Characteristic PA66 plastics have higher melting points in polyamide materials. It's a semi-crystalline-crystalline material. PA66 also maintains strong strength and stiffness at higher temperatures. PA66 plastics are still hygroscopic after molding, the degree of which depends on the composition of the material, 

wall thickness and environmental conditions. The effect of hygroscopicity on geometric stability must be considered in product design. Various modifiers are often added to improve the mechanical properties of PA66. Glass is one of the most common additives, sometimes added to make it more resistant to synthetic rubber. PA66 plastics have a low viscosity and therefore a good fluidity (but not as good as PA6) . This property can be used to machine very thin components. Its viscosity is sensitive to changes in temperature. The shrinkage of PA66 is between 1% ~ 2% . The shrinkage of PA66 can be reduced to 0.2% ~ 1% by adding glass fiber additive. The difference of shrinkage in the process direction and in the direction perpendicular to the process direction is large. The melting point of thermal property of PA66 plastics is the temperature of crystallization melting. The melting point of crystalline polymer PA66 plastics is clear. According to the test method, the melting point fluctuates in the range of 259 ~ 267 °C. The melting point of PA66 plastics measured by DTA is 264 °C. The melting temperature range of nylon-66 is 246 ~ 263 °C if the temperature at which the volumetric expansion coefficient shows its maximum value is taken as the melting point. Approximate theoretical melting temperature 259 °C. INJECTION MOLDING CHARACTERISTICS OF PA66 PLASTICS DRYING TREATMENT: If the material is sealed before processing, there is no need to dry. However, if the storage container is opened, drying in hot air at 85C is recommended. If the humidity is greater than 0.2% , 105C, 12 hours of vacuum drying is also required.