DXN-T高壓帶電顯示器DXN-T顯示器
聯系人：王總 聯系電話：0577-27880112 手機：手機：13362763534
DXN-T型戶內高壓帶電顯示裝置產品詳細說明：
DXN（GSN）-T／Q型戶內高壓帶電顯示器（以下簡稱顯示器），適用于交流50Hz、額定電壓10kV～35kV戶內高壓電氣設備， 用于顯示高壓線路帶電狀態，DXN（GSN）-可同時閉鎖高壓電氣設備，以防止電氣誤操作，誤入帶電間隔。顯示器配合高壓帶電傳感器構成高壓帶電顯示裝置，符合DL／T538-93《高壓帶電顯示裝置技術條件》和DL740-2000《電容型驗電器》有關技術指標的綜合要求。
技術參數
1、帶電顯示
顯示DXN-T／Q提供開關設備高壓線路帶電狀態的顯示。帶有按鍵功能的顯示器，在按鍵壓入時顯示電氣設備的高壓線路帶電狀態，測試完畢后按鍵復位。
2、電氣閉鎖
顯示器DXN-Q提供電氣閉鎖功能。電氣設備的高壓線路帶電時顯示器將控制繼電器或電磁鎖閉鎖高壓電氣化設備的接地開關或電氣間隔，僅在電氣設備高壓線路不帶電且顯示器有輔助電源時，提供電氣解鎖。
3、驗電／核相
顯示器上的驗電／核相端口提供外接檢測端口，需要配合驗電／核相器DXN-C使用。
驗電／核相器插入到驗電端的接地端口和其它相序端口，若有顯示表示測試相序帶電。
驗電／核相器插入到兩臺開關設備驗電端的同一相序，若沒有顯示表示測試的相序相同。
安裝使用
顯示器適合開關設備面板安裝，接線按原理圖連接。顯示器連接的保護線纜分別連接傳感器分壓
DXN-T顯示器、DXN-T顯示器、DXN-T顯示器、DXN-T顯示器、DXN-T顯示器、DXN-T顯示器、DXN-T顯示器、DXN-T顯示器
英文翻譯：
DXN-T indoor hv charged display device products details:
DXN (GSN) T/Q type indoor hv charged displays (hereinafter referred to as the display), is suitable for use in ac frequency 50 Hz, rated voltage 10 kV ~ 35 kV indoor hv electric equipment, to display high-pressure line charged state, DXN (GSN)-can also atresia high voltage electrical equipment, in order to prevent the electrical wrong operation, go charged interval. With a high pressure sensors monitor charged high voltage hot-line display device, accord with DL/T538-93 "high voltage hot-line display device technology conditions" and DL740-2000 "capacitance type check appliances" about technical indexes of comprehensive requirements.
Technology parameters
1, charged display
Display DXN-T/Q provide switch equipment high-pressure line of state charged display. With keys function display, fashion shows in key pressure electric equipment of high-pressure line charged state, test after the completion of the reset button.
2, electrical atresia
Display DXN-Q provide electrical atresia function. Electrical equipment in the high-pressure line monitor will be charged the control relay or electromagnetic lock in high pressure electrification of the lock equipment grounding switch or electrical interval, only in electrical equipment high-pressure line not charged and displays have assisted the power supply, provide electrical to unlock.
3, check electric/nuclear phase
On the monitor of check electric/nuclear phase port provide external detection port, the need to cooperate with check electric/nuclear phase detectors DXN-C use.
Check electric/nuclear phase inserted into the electricity to check grounding port and other sequence port, if a show said test sequence charged.
Check electric/nuclear phase inserted into two sets to switch equipment check the electricity the same sequence, if not show the same sequence said test.
Installation using
The display for switch equipment panel installation, wiring according to principle diagram connection. The monitor linked to protect cable connection sensor points respectively the pressure and the corresponding display terminals, ground must be reliable grounding.
